We are searching data for your request:
Upon completion, a link will appear to access the found materials.
Moles destroy fruit trees by digging trenches around the trees root system. Voles will commonly girdle a young tree by consuming the bark all the way around the tree, killing it. Both moles and voles can be controlled by trapping.
Place a minimum of 25 spring/snap mousetraps to catch voles in a half acre orchard. Spread the traps liberally around the area to successfully eradicate the voles. An acre orchard should have a minimum of 50 spring/snap mousetraps. Utilizing 25 traps per every half acre will kill off the mole population over the course of several days.
- Moles destroy fruit trees by digging trenches around the trees root system.
- Spread the traps liberally around the area to successfully eradicate the voles.
Bait each spring/snap mousetrap with a mixture of 75 percent peanut butter and 25 percent oatmeal. Apply a small amount to each trap spring plate.
Place the traps at a right angle to the runway tunnels. The runway tunnels are the main tunnels that the voles use to reach the fruit trees. Place the mousetraps into the actual runway path by sticking the mousetrap down the vole hole.
Remove all dead voles daily and dispose of the bodies so animals are not attracted to the site. Place fresh bait on the traps and reset. Continue this practice until all voles are gone. Destroy the holes and runways so new voles do not move into the location. Mow the grass closely around the fruit trees and make sure there is no accumulation of thatch to attract more voles to the area.
- Bait each spring/snap mousetrap with a mixture of 75 percent peanut butter and 25 percent oatmeal.
- Destroy the holes and runways so new voles do not move into the location.
Locate a main mole runway by stomping down the soil on a runway tunnel. Wait until the next morning to see if the moles have dug out the dirt that was stomped down and repaired the tunnel.
Dig a hole approximately 18 inches from a mole dirt mound into the main runway. Make the hole just big enough to slip the harpoon or scissor trap into. Form a mound of dirt in the bottom of the hole for the strike plate to rest upon. Form a dirt plug mound which will allow the strike plate to lie level so the mole will easily step on the strike plate to set off the trap.
Set the safety on the trap and gently lower it into the hole. Make sure the trap plate fits snugly over the dirt plug mound. Fill in the hole with loose dirt up to the dirt level mark on the trap. Release the safety mechanism.
- Locate a main mole runway by stomping down the soil on a runway tunnel.
- Set the safety on the trap and gently lower it into the hole.
Check the traps every day. Promptly remove all dead moles and reset the traps in a new runway. Remove when you are certain there are no more moles in the area.
Repair the tunnels around the fruit trees so the trees roots do not become exposed and damaged. Walk along and push the tunnels in using your feet and a shovel. Fill in the holes where the tunnels were with surrounding soil or bring soil in to fill up the holes.
Moles produce tunnels and mounds of soil. A vole will also dig tunnels but leave actual holes in the ground for exits. This is the way to tell the difference between mole or vole tunnels.
A scissor trap kills by snapping the mole in what appears to be a large pair of scissors. A harpoon trap has a metal stake that drives into the mole, killing it.
Keep all pets and children away from mole and vole traps. Always wear gloves when disposing of mole or vole carcasses. Hose off the traps if they contain blood particles. Dry the traps with a dry cloth.